戰地風雲 6 安全開機錯誤：如何在 Windows 11 上修復
為何《戰地風雲 6》需要安全開機與 TPM？
If Battlefield 6 shows a “SecureBoot is not enabled” 或 “Secure Boot is not enabled” error when you launch the game, your PC may not meet the security requirements checked by EA Javelin anticheat. In most cases, the problem is related to Secure Boot, TPM 2.0, 、UEFI 模式，或是您的 Windows 系統磁碟的分區樣式。.
好消息是， Battlefield 6 Secure Boot error is usually fixable without reinstalling Windows. You mainly need to check whether TPM 2.0 is available, confirm that Windows is booting in UEFI mode, make sure the system disk uses GPT when required, and then enable Secure Boot in BIOS/UEFI.
在變更 BIOS 或磁碟設定之前，請仔細閱讀以下步驟。不正確的開機設定可能會導致 Windows 無法啟動，尤其是當您的電腦使用 BitLocker，或是在傳統 BIOS 模式下安裝 Windows 的情況下。.
目錄
《戰地風雲 6》安全開機錯誤的快速解決檢查清單
To fix the Battlefield 6 Secure Boot error, go through this checklist first:
- 新聞 贏 + R, 類型
msinfo32, 並檢查 BIOS 模式 和 安全開機狀態. - 新聞 贏 + R, 類型
tpm.msc, and confirm that TPM 2.0 is ready for use. - Check whether your Windows system disk uses GPT 或 MBR.
- If Windows is installed in Legacy BIOS mode on an MBR disk, use Microsoft’s MBR2GPT tool to validate and convert it.
- 進入 BIOS/UEFI 設定並啟用 UEFI mode, TPM 2.0, and Secure Boot.
- Restart Windows and verify that 安全開機狀態 顯示 關於.
- 再次啟動《戰地風雲 6》。.
If Secure Boot is unsupported, greyed out, or Battlefield 6 still reports that it is disabled after you enable it, check the troubleshooting section later in this guide.
為何《戰地風雲 6》需要安全開機與 TPM 2.0
Battlefield 6 requires TPM 2.0 and UEFI Secure Boot as part of its official PC security requirements
Modern cheat programs may attempt to operate at a very low system level. Secure Boot helps verify that trusted boot software loads when the PC starts, while TPM 2.0 provides hardware-backed security functions that Windows and security software can use to verify system integrity.
In simple terms, the Battlefield 6 Secure Boot requirement is not just a game setting. It is connected to how Windows starts, how your motherboard firmware is configured, and how the system drive is partitioned.
That is why simply reinstalling Battlefield 6 usually does not fix this particular error.
啟用安全開機前的檢查清單
檢查是否已啟用 TPM 2.0
檢查磁碟是否為 MBR 並將其轉換為 GPT (為安全開機做準備)
對於一個 MBR 磁碟，Windows 10/11 提供官方 MBR2GPT.exe 公用程式將其轉換為 GPT。.
以下是使用方法：
1.按一下開始功能表並輸入 CMD。. 以管理員身份執行 Command Prompt。.
如何在 BIOS 中啟用安全開機和 TPM (逐步進行)
1.進入 BIOS/UEFI 設定
重新啟動電腦，並按下開機時顯示的按鍵 (例如、, Del / F2 / F10) 進入 BIOS。.
確認是否已啟用安全開機與 TPM
用於安全開機：
1.Press WIN+R 在鍵盤上輸入 “msinfo32“
用於 TPM：
1.Press WIN+R 在鍵盤上輸入 “tpm.msc“
如果您覺得這些步驟太複雜，還有一個 更快速的解決方案。.
Secure Boot Is On but Battlefield 6 Still Says It Is Not Enabled
有時 msinfo32 already shows 安全開機狀態：開啟, but Battlefield 6 continues to display a Secure Boot or EA Javelin anticheat error.
If that happens, do not immediately disable and re-enable random BIOS options. Check the following first.
Confirm Windows Is Actually Using UEFI
開啟 msinfo32 again and make sure:
- BIOS 模式：UEFI
- 安全開機狀態：開啟
Both should be correct.
Verify Secure Boot with PowerShell
Advanced users can also open PowerShell 作為管理員 並執行：
Confirm-SecureBootUEFI
If Windows reports:
正確
Secure Boot is enabled and recognized by Windows.
Check the Secure Boot Keys
On some motherboards, Secure Boot can appear enabled while the required platform keys are not configured correctly.
Enter BIOS and look for options such as:
- Install Default Secure Boot Keys
- Restore Factory Keys
- Key Management
- Secure Boot Mode: Standard
Use the motherboard manufacturer’s instructions before changing key-management settings.
Make Sure CSM Is Disabled
Secure Boot normally requires a full UEFI boot environment. If Compatibility Support Module (CSM) or Legacy Boot is still active, disable it after confirming that Windows can boot in UEFI mode.
Restart the EA App and Battlefield 6
Fully close Battlefield 6, Steam if applicable, and the EA app.
Then restart the EA app and launch the game again.
If you receive a separate EA Javelin anticheat error, running the EA app as administrator and launching Battlefield 6 directly from the EA app may help.
Reinstall EA Javelin Anticheat If Necessary
If Secure Boot and TPM 2.0 are correctly detected by Windows but Battlefield 6 reports a Javelin anticheat error, reinstalling EA Javelin anticheat may resolve a damaged anticheat installation.
This should be treated as an anticheat troubleshooting step, not as a replacement for correctly enabling Secure Boot.
Check for a BIOS/UEFI Update
Older firmware can sometimes cause problems with TPM, Secure Boot keys, or security-feature detection.
Check your PC or motherboard manufacturer’s official support page for firmware updates that apply to your exact model.
Before Changing BIOS or Partition Settings
Changing Secure Boot itself does not normally delete personal files. However, converting partition layouts or changing UEFI, TPM, and firmware settings can affect how Windows or encrypted drives start.
Before making these changes:
- Back up important files.
- Make sure you know which disk contains Windows.
- Save your BitLocker recovery key if BitLocker or Device Encryption is enabled.
- Avoid changing unrelated BIOS settings.
Changes to TPM, Secure Boot, or firmware configuration can sometimes cause BitLocker to request the recovery key during startup. If you are unsure where it is stored, see our guide on how to 尋找 BitLocker 復原金鑰.
For users who need to check whether important Windows or software keys have already been stored locally, Magic Recovery Key can also be used as an optional key-management tool before making system changes.
However, installing additional software is not required simply to fix the Battlefield 6 Secure Boot error. The main goal is to correctly configure Windows, UEFI, Secure Boot, and TPM 2.0.
總結
的 Battlefield 6 Secure Boot error usually appears when Secure Boot, TPM 2.0, UEFI mode, or the Windows system disk configuration does not meet the game’s security requirements.
從 msinfo32 和 tpm.msc. If Windows is running in Legacy BIOS mode on an MBR system disk, validate the disk with MBR2GPT before converting it. Then switch the firmware to UEFI mode and enable Secure Boot and TPM 2.0.
If Secure Boot already shows 關於 but Battlefield 6 still reports an error, check the Secure Boot keys, CSM status, firmware version, and EA Javelin anticheat rather than attempting unsupported workarounds.
Most importantly, do not try to bypass the Secure Boot requirement. Correctly configuring Secure Boot is more reliable and is less likely to cause future Battlefield 6 anticheat problems.
Before changing BIOS, TPM, or disk settings, back up important files and keep your BitLocker recovery key available. With the system configured correctly, you should be able to resolve the Battlefield 6 Secure Boot error and launch the game normally.
常見問題
如何解決《戰地風雲 6》的安全啟動錯誤？
為什麼《戰地風雲 6》需要「安全開機」功能？
玩《戰地風雲 6》需要 TPM 2.0 嗎？
是否可以在不將 MBR 轉換為 GPT 的情況下啟用安全開機？
「安全啟動狀態不支援」是什麼意思？
為什麼 BIOS 中的「安全開機」選項會顯示為灰色？
玩完《戰地風雲 6》後，可以停用 Secure Boot 嗎？
